Updated : May 08, 2020 in Portable Devices

649-M2 REV 1.0B DRIVER

Audio Ports Use the three audio ports to connect audio devices. The second jack is for stereo line-out signal. When installing a CPU heatsink and cooling fan make sure that you DO NOT scratch the motherboard or any of the surface-mount resistors with the clip of the cooling fan. Power On After Power Fail Off This item enables your computer to automatically restart or return to its last operationg status after power returns from a power failure. Jumpers with more than one pin are numbered. You might need to run the Setup Utility and change the boot priority items on the Advanced BIOS Features Setup page, to force your computer to boot from the floppy diskette drive first. However, there is no guarantee that interference will not occur in a particular installation.

Uploader: Sak
Date Added: 1 August 2009
File Size: 70.67 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 95314
Price: Free* [*Free Regsitration Required]

You’re covered by the eBay Money Back Guarantee if you receive an item that is not as described in the listing. Handle the modules only by their edges. Take a look at our Returning an item help page for more details.

The documentation of your IDE device explains how to do this. You might like to enable this item after you are confident that your system hardware is operating smoothly.

Floppy Disk Connector This connector supports the provided floppy drive ribbon cable. If 649-,2 CPU do support L3, you may set this item to enable or disable. You cannot make changes to these fields. Be careful not to touch the contacts. High figures will improve performance.


Get the item you ordered or your money back. AbouttheManual The 1.0n consists of the following: This equipment generates, uses, and can radiate radio frequency energy and, rv not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

Before attempting to configure a hard disk drive, ensure that you have the configuration information supplied by the manufacturer of your hard drive.

ECS 649-M2 manual

Otherwise, leave this item at the default. Shutdown Temperature Disabled Enables you to set the maximum temperature the system can reach before powering down. Use the cursor arrow keys to move the highlight to other 1.00b. Use the section item Reserved Memory Length to set the amount of reserved memory. In the Memory Resources submenu, use the first item Reserved Memory Base to set the start address of the memory you want to reserve for the ISA expansion card.

Onboard serial port header Connect a serial port extension bracket to this header to add a second serial port to your system. Follow these instructions to install an add-on card: Please make sure that you describe your difficulty with the ECS M2 as precisely as you can. Visit my eBay shop. Seller assumes all responsibility for this listing.


The firmware can also be used to set parameters for different processor clock speeds. FDD, COM, LPT Port Disabled When this item is enabled, the system will restart the power-saving timeout counters when any activity is detected on the floppy disk 1.b0, serial ports, or the parallel port. Add to Watch list Watching Watch list is full.

Carte mere ECS M2 rev B socket | eBay

International postage and import charges paid to Pitney Bowes Inc. Apply thermal grease on top of the CPU. Install new BIOS as follows: If the clip of the cooling fan scrapes across the motherboard, you may cause serious damage to the motherboard or its components. After connecting the single end to the onboard floppy connector, connect the remaining plugs on the other end to the floppy drives correspondingly. IrDA is an infrared communication protocol with a maximum baud rate up to If no device is installed, change the value to None.

Go to H page 1 Describes installation of motherboard components. See other items More Please enter a number less than or equal to 1.